3/14/2021 0 Comments Arduino Dfu Programmer
Its not as easy to use as UF2, but it isnt too difficult either.Simply connect the BOOT0 ( B0 ) pin to 3.3V logic.Then press the reset button or power cycle while the board is connected to your computer USB port.Its a graphical programmer, does not require Zadig or special command line invocation.
![]() If not, enter bootloader mode by connecting BOOT0 to 3.3V and resetting, and click the refresh button. This page (DFU Bootloader Details) was last updated on Aug 31, 2020. ![]() Easily make an expandable Sip and Puff using the ST LPS33 sensor, STM32F405 Feather, and CircuitPython. Please remember that this subscription will not result in you receiving any e-mail from us about anything other than the restocking of this item. Arduino Dfu Programmer Code Accounts ForThe remaining 10 percent of the code accounts for the other 90 percent of the development time.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |